The Dimming 5 calculator allows a given level of illuminance to be assigned to different times of the day (2 to 5 slots). Based on the daily operating time of the luminaire, a microprocessor in the power unit is able to determine the “heart of the night”; dimming periods are adjusted around the “heart of the night” thus defined. The adjustment times and levels are pre-programmed at the factory.
This module, to be installed at the base of the pole, allows you to:
- change the LED constant current setting, adjustable current.
- apply dimming scenario, dimming controller.
This option allows you to select a reduced power range from predefined scenarios, with two thresholds at the beginning and end of the night. This is assigned a lighting level with high and low setpoints. The parameters are set at the factory and can be changed on site after installation.
The CA2P Bluetooth module is installed on ECLATEC luminaires and communicates with the D4i driver.
It allows you to control the luminaire:
- By defining up to 6 reduced power ranges and configuring the corresponding time slots.
- By configuring an all night power setting
- Switching on, switching off, configurable power variation from 0 to 100 %.
- Reading of consumption data (number of hours of operation, energy consumed, power and voltage).
- Operating status of the appliance.
This option allows you to adjust the supply current for the LEDs. The factory-set power can be changed on site after installation of the luminaires. This can be done by a qualified electrical worker by adjusting a rotary switch on a module mounted at the foot of the mast, without interrupting the power supply.
This module communicates with the luminaire via a DALI protocol.
It can then be easily switched to a remote management system using the same protocol.
The CLO option compensates for the depreciation of the luminaire by gradually increasing the LED supply current, independently and according to the number of operating hours.
The luminaire’s luminous flux is thus kept constant throughout its operating life, always providing the optimal amount of light required.
The CLO function only concerns certain luminaires (see table of LED solutions); it can be activated without other options, but is also compatible with Dimming 5 and Motion 5.